SM-CMD2023DVD/MP3/CD RECEIVER DVD/MP3/CD Instruction manual
10ISO connectorPLEASE USE ONLY ORIGINAL CONNECTOR THAT GOES WITH SET.Note: In spite of having any kinds of speaker system, must use 4 ohms impedance
11Remote controller (RC)1. MODE button2. POWER button3. UP button4. BND/SYS button5. ENTER button6. LEFT button7. STOP button8. ST/PROGRAM but
12Battery information of remote controller1. Press the catch and at the same time pull out the battery tray.2. Insert the 1 x lithium battery, type CR
13GlossaryPBC (PlayBack Control)PlayBack Control is a menu recorded on the disc with SVCD or VCD2.0 format. For the discs contained PBC, it canplaybac
14General operationPower buttonPress POWER button on the front panel or any other button on the panel except EJECT to turn on the unit.Press POWER to
154. Rotate the control to set the minutes.5. Press PTY/CLK button, or leave the unit idel. Time setting is now confirmed.Press PTY/CLK button to show
16Digital tunerChoose Radio BandPress MOD button to access the radio function. Press BND button to select the needed radio band. The unit comeswith fi
17Press APS button to scan all preset stations in the memory of the current band and stay on each memory stationabout 5 seconds. To stop preset scan,
18DVD/VCD/CD/MP3/CD-RDiscs for playback This set can play all digital audio CD, HDCD, CD-R/RW, MP3, WMA, VCD, SVCD, DVD,DVD-ROM. The following fil
19OSD (Display information)Press the OSD button (by pressing and holding button 1 on the front panel, or pressing the OSD button on the RC)so that the
2Dear customer!Thank you for purchasing our product. For safety, it is strongly recommended to read this manual carefully beforeconnecting, operating
20Press the No.3 button to navigate the setup menu upward. Press and hold the button for 3 seconds to play the first10 seconds of each track. “INT” wi
21Zoom +/-Press the ZOOM button on the RC to perform the zoom function. The zoom range is from 1/4 up to 4 (total 7 stages),according to the zooming i
22Mixed-disc operationWhile you are playing mixed disc, which contains MP3, WMA, JPG or DIVX formats, just insert the disc into the CDslot and the men
23Picture of play-list menu
24VCD/CD operationInsert/Eject CDInsert a disc into CD slot with label side up. The disc will be automatically loaded into the unit, even when it is o
25Electronic Shock ProtectionElectronic Shock Protection (ESP) is ideal for driving on rough roads. This unit is programmed with Electronic ShockProte
26AUX IN, RCA OUT, SUB OUT & Video OUTAuxiliary InputThe Auxiliary Input Jack is on the rear of unit. Insert the RCA plugs into the AUX IN jack on
27System setupPress SETUP button on the RC to display setup screen, use , ENTER buttons to select the desired item: System,Language, Audio, Video,
28 Language setupSetting the on-screen display languageSelect the language to be used for the on-screen display.Setting the audio languageSelect the l
29Video setupBrightness.Set the brightness of the video output with .ContrastSet the contrast of the video output with .Hue. Set the hue of the
3Important safeguards Using the device at temperature below -10º may cause the breakage of the device. BEFORE USING PLEASEHEAT UP THE PASSENGER COM
30Anti-theft systemRemoving the panel1. Press POWER button to switch off the power of the unit.2. Press EJECT button to flip down the panel.3. Hold th
31Handling discs Dirty, scratched or warped discs may cause skip ping or noise. Handle the disc only by the edges. To keep clean do not touch its
32Troubleshooting guideSymptomCause SolutionGeneralNo powerThe car ignition is not on.The fuse is blown.If the power supply is properly connected to t
33SpecificationGeneral. Power supply:12V DCCurrent consumption/Fuse:10A & 1AMaximum power output: 50Wx4 channelsDimensions (W x H x D) 178 x 51 x
34! .
35 -10º .
36 . ,
373. ., , . ,
39 ISO1. ISO, , .2.
4Installation/ConnectionsFirst complete the electrical connections, and then check them for correctness. If you are not confident working withelectric
401. VOLUME-UP/DOWN, SEL MENU2. 3. 4. 5. AUX6. POWER7.
41 , .: RESET
42ISO , .:
43 ()1. MODE2. POWER3. UP ()4. BND/SYS5. ENTER6. LEFT ()7.
441. .2. CR 2025 3, (+)
45PBC () – , .
46 POWER EJECT, .
47.2. VOLUME, .3. VOLUME, .
48 MOD . BND . 5
49B. APS ;
53. Insert trim plate.When you prepare to insert trim plate, please check it’s direction. Once it was up side down, it cannot be fixed.NOTE: Outer tri
50. (1-6) .
51DVD/VCD/CD/MP3/CD-R CD, HDCD, CD-R/RW, MP3,WMA, VCD,SVCD, DVD
52 () 1 OSD .
53 3: 3 . 3
54 GOTO . . ,
55, MP3, WMA, JPG DIVX, ,
56
57 VCD/CD: EJECT, .
58. :)--> ()--> ()
59 AUX, RCA, , AUX AUX .
6
60 SETUP , , ENT
61:, .
62. : . SPDIF/ RAW:
63: LT/RT, , .: LINE
641. POWER, .2. OPEN, .3.
65 , (
66 ..
67. 12 , : 10A & 1A: 50
7Using the ISO Connector1. If your car is equipped with the ISO connector, then connect the ISO connectors as illustrated.2. For connections without t
8Panel controlsFront panel1. VOLUME-UP/DOWN, SEL MENU knob2. Disc slot3. Display4. IR sensor5. AUX input6. POWER button7. UP/DOWN, MOD knob8. T
9Back of the front panelPress the button to open the panel.Note: Pressing the RESET hole will erase the clock setting and stored stations.Panel statu
Comments to this Manuals